
Sometimes a finely set smoothing plane with a freshly honed iron, the chip breaker as close to the edge as you can get it, a high angle and a tight mouth is not enough. You still get tear-out. If it is confined to small areas it is enough to bring out a card scraper; otherwise you need a scraping plane. It helps keep the surface flat. It is easy to dig a little hollow with a hand-held scraper.
There are a few different kinds of scraping plane; the picture shows three of mine. A Stanley (I think) #12 (I know) with a toothed blade, a Veritas scraping plane (Cabinet Scraper) and a Lie-Nielsen #85.

If you are only going to have one scraping plane, the Veritas model, or perhaps a Stanley #80, which it is based on, is a good choice. You sharpen the blade of a scraping plane in two steps. First you hone the edge like an ordinary plane iron and polish the back so that the wire edge comes off. Then you turn a hook with a burnisher. I hone at 45 degrees, which gives a strong and durable edge, and polish the back using David Charlesworth's “ruler trick”. To turn the hook I use a simple guide, a piece of MDF with one edge sawn at 75 degrees. It prevents you from turning the hook too far.
A few strokes with the burnisher, not particularly hard ones, give a good hook. You should only just be able to feel it when you draw a fingertip over the back of the blade. Run your finger along the back towards the edge, and if you feel a slight tickle it is just right.

The easiest way to set the blade correctly in a #85 is to fit the blade, stand the plane on a flat surface, for example a piece of MDF, put a piece of paper under the toe and loosen the blade so that it drops onto the surface. Clamp the blade, and the plane is set to take a shaving about half the thickness of the paper.
To set up a #80: stand the plane on a flat surface and loosen the blade so that it sits flush with the sole. Tighten it. Then use the small screw at the back to set the thickness of the shaving. Turn it only a little at a time and test.

And here is the proof that it works.
To see how I sharpen an ordinary card scraper, have a look at this old post.
Share this content