Search on blog

Buy a Gift Card

Sharpening a Card Scraper

The Plane Doctor
star
star
star
star
star
Be the first to rate
Lie-Nielsen card scrapers

A card scraper is a rectangular piece of thin sheet steel, hardened slightly harder than the blade of a handsaw. I have tried scrapers from Bahco, Veritas and Lie-Nielsen and cannot say there is any great difference between them.
The trick with a scraper is, as usual, to get it sharp in the right way. Unlike a plane iron, you turn a small hook on the edge of the scraper using a burnisher. The hook is what cuts the shavings, and it does so at such a high angle that the risk of tear-out disappears and the surface becomes smooth.

My woodworking hero Chris Schwarz has a good article here. He has also released a pretty good DVD on the subject.
This is my take on it.

Here is the equipment I use: a King 800 stone, a King 8000, a coarse diamond plate for flattening the stones, a single-cut file and a burnisher. You also need a couple of pieces of wood from the offcut bin.

Step 1
File the edge straight. I put the scraper in the front vise and place a block of wood next to it so that the scraper protrudes half a millimetre or so. That helps me guide the file square. I colour the edge with a black marker so I can see what is being filed away. It is done when the colour is gone.

Step 2
Hone both edges on the coarse stone (800), supported against a block of wood. Turn the block so that the scraper does not wear a groove in the same place on the stone.

Step 3
Hone all four long faces on the coarse stone.

Step 4
Polish the edges on the fine stone (8000) in the same way as before.

Step 5
Polish all four long faces on the fine stone. I put a ruler under the scraper so that only the very edge nearest the cutting edge is polished. It saves a lot of time and effort.

Veritas round burnisher

Step 6
“Tick” the edge. Yes, that is the sound when you draw the burnisher back and forth along the edges of the scraper.

Step 7
Turn the hook by drawing the burnisher horizontally a couple of times and then a few times angled down about 10–15 degrees. Feel with your finger that a small hook has formed. You cannot see it, but it tickles a fingertip a little.

Done!

A scraper should cut shavings, not dust.

Swedish glossary: sickel = card scraper, sickelstål = burnishing iron, burnishing rod.

Share this content

0.0 0 votes
Please log in to rate this post