Search on blog

Buy a Gift Card

There has been more woodworking than blog updating lately. Now I need to catch up with the documentation!

To have something to attach the tail vise screw to, I made a 75 mm thick end cap that I fasten with long 10 mm bolts. To locate it correctly I fitted a row of 10 mm Domino tenons, which make sure I can remove it and put it back in the same place. I think I will need to do that quite a few times before the benchtop is finished.

Now the end cap is bolted in place and the remaining two boards clamped up. It is coming together! The finished width of the bench will apparently be about 52 cm. That feels about right. Originally I was thinking 60 cm, but now it feels as if that would be too wide. The two bolt holes nearest the back edge of the bench are slightly enlarged to allow the top to expand a little towards the back with seasonal movement. The corresponding Domino mortises in the top are also one size wider than the tenon. I do not expect very large movements, though, as the growth rings in almost all the boards are vertical. That means the top will change in thickness rather than in width. (Beech shrinks from green to 0 % moisture content by 4.4–5.9 % radially and 10–11.8 % tangentially, and from green to 12 % moisture content by 4.5 % radially and 9.5 % tangentially, according to the Swedish Wood Centre’s website.)

With the end cap temporarily in place, I could glue on the template for the holes for the tail vise mounting plate. I also marked out the length of the end cap. Then it is just a matter of drilling and cutting.

Now the dog hole strip is in place – the board with holes for bench dogs, glued on. To make the glue-up easier I fitted a couple of Domino tenons, which both keep the top edge flush with the top of the bench and make sure one end lines up correctly with the tail vise. A little masking tape helps keep glue squeeze-out under control, especially in the opening for the tail vise, where it is hard to remove later.

I will drill 3/4″ (19 mm) holes for bench dogs and holdfasts and thus use round shafts instead of the classic square ones. My reasons are that it is simpler, that both dogs and holdfasts fit in every hole, and that I can fairly easily make a bench dog for each hole from dowel.

So, the last board is glued in place. It got a bit stressful getting bolt, washers and nut to cooperate so I could draw it up to the end cap and get the clamps on before the glue had set too much. It went fairly well, but the joint could have been a little better. You always need more clamps. The end cap is now cut to length and the holes drilled according to the template. It turned out that my auger bits were just long enough. Half a centimetre thicker stock and I would have had to come up with some clever solution. Around the large hole I routed a seven-millimetre rebate using a cutter with a suitable bearing.
With the top glued up, the next step is to plane the underside reasonably flat and then rout grooves for the tail vise and the sliding deadman (the Swedish term I came up with translates as something like “the sliding dead old man” – better suggestions welcome!).

Previous part: The Adventure Continues. Continued: A Workout in the Garage.

Share this content

0.0 0 votes
Please log in to rate this post

Discover more

6 July 2011 | The Plane Doctor
10 August 2011 | The Plane Doctor

The Adventure Continues

21 August 2011 | The Plane Doctor

A Workout in the Garage

The Router Plane to the Rescue!
24 August 2011 | The Plane Doctor
12 November 2011 | The Plane Doctor

Almost Done…