Back from the summer holiday, I have been able to put a few hours in the garage into continuing work on my bench.
I have now glued the two large blocks together. It was not as easy as I had hoped! I had to spend quite a lot of time planing both edges straight and square to get a tight joint. It went so-so. The joint could have been neater, but it will do for a workbench. My advice to others is to glue up one board at a time, but then there is more work flattening the bench by hand later. Whichever way you turn, your backside is always behind you.
When the glue had dried I cut the top square at both ends with my plunge saw. I had to cut from both sides and take the last millimetre with a ryoba, a Japanese saw. The next step was to plane the right-hand end straight and square. That is important for the tail vise to work. The left-hand end only needs to look good.
This is a good job for a block plane. I started with my Veritas NX60. I have a straight blade in it, but soon realised I needed a cambered blade to get it to cut in the right places to adjust the angle of the end. Out came my old faithful LN 60 ½, one of my favourite planes! Cleaning up after the saw went surprisingly easily.
With the end tidy, it was time to lay out the recess needed for the tail vise. I am using a so-called wagon vice from Benchcrafted. It seems functional, solid and good-looking.
After a couple of hefty workouts with a router, chisels, gouges, a few different planes and finally a card scraper, the recess is done.
Share this content