
I have now nailed the bottom onto the chest. To allow for some movement I planed a tongue and groove joint on the bottom boards. A good opportunity to use my Lie-Nielsen 48 (3/4" tongue and groove plane).

To make it look a little nicer on the inside, and so that you don't notice the gap between the boards so much, I planed a small bead on the groove side. This was a job for my BCTW HP-6v2.

Then it was just a matter of marking out the nail line, stepping off where the nails should go with a pair of dividers, drilling holes for the nails and driving them in. I used cut nails from the Tremont Nail Company, which I bought from Rudlands.co.uk since there was no dealer in Sweden.
Previous part: An Anarchist's Tool Chest. Continued: The Lower Skirt.
Share this content