Search on blog

Buy a Gift Card

An Anarchist's Tool Chest

The Plane Doctor
star
star
star
star
star
Be the first to rate
Knocking the corners of the tool chest together with a mallet

OK, I have finally given in and started building a tool chest à la Schwarz's Anarchist's Tool Chest. I'm cheating a little and starting from Hornbach's 18 mm laminated pine panels. The carcase itself went together fairly quickly, with through dovetails at all four corners. Dovetailing pine is both easy and hard. Easy because it doesn't matter much if the fit is a little tight. The wood compresses and the joint becomes tight. Hard because you need sharp chisels to clean out between pins and tails. The end grain easily crumbles and comes away as one big piece.

Through dovetails at the corner of the tool chest

With a little luck and after a bit of fine-tuning, the joints fitted together and gluing up the carcase went well. I used Titebond Liquid Hide Glue, which I probably use for most things that won't be exposed to moisture. A few thumps with the rubber mallet and a few clamps helped get everything in place. Glue-ups are always just as stressful when there are lots of parts to fit together at the same time.

Planing the joints flush with pencil scribbles as a guide

When the glue had dried I planed the joints flush and could see how well I had done. Pretty decent, I think. A tip when planing is to scribble on a little pencil so you can see where you have finished planing and where you need to take more.

Continued: Bottom of the Chest. The finished chest: The Tool Chest Is Now Moved In.

Share this content

0.0 0 votes
Please log in to rate this post

Discover more

Bottom of the Chest
11 May 2014 | The Plane Doctor

Bottom of the Chest

The Lower Skirt
27 May 2014 | The Plane Doctor

The Lower Skirt

The Tool Chest Is Now Moved In
3 February 2015 | The Plane Doctor
On a Course With Chris
7 July 2012 | The Plane Doctor

On a Course With Chris

15 June 2013 | The Plane Doctor

On the Way to Dictum