Search on blog

Buy a Gift Card

Tongue and groove planed on the bottom boards of the tool chest

I have now nailed the bottom onto the chest. To allow for some movement I planed a tongue and groove joint on the bottom boards. A good opportunity to use my Lie-Nielsen 48 (3/4" tongue and groove plane).

Bead planed on the groove side of a bottom board

To make it look a little nicer on the inside, and so that you don't notice the gap between the boards so much, I planed a small bead on the groove side. This was a job for my BCTW HP-6v2.

Cut nails driven into the bottom of the tool chest

Then it was just a matter of marking out the nail line, stepping off where the nails should go with a pair of dividers, drilling holes for the nails and driving them in. I used cut nails from the Tremont Nail Company, which I bought from Rudlands.co.uk since there was no dealer in Sweden.

Previous part: An Anarchist's Tool Chest. Continued: The Lower Skirt.

Share this content

0.0 0 votes
Please log in to rate this post

Discover more

An Anarchist's Tool Chest
5 May 2014 | The Plane Doctor

An Anarchist's Tool Chest

The Lower Skirt
27 May 2014 | The Plane Doctor

The Lower Skirt

Almost Done With the Chest Itself!
1 June 2014 | The Plane Doctor
Lid and Paint
2 July 2014 | The Plane Doctor

Lid and Paint