Search on blog

Buy a Gift Card

On a Course With Chris

The Plane Doctor
star
star
star
star
star
Be the first to rate

For the past three years I have gone on a woodworking course at Dictum near Deggendorf in Bavaria, all three times with Chris Schwarz as the instructor. The first time was about classic joinery with hand tools, and we built a small Shaker cabinet. The course lasted five days and gave a good introduction to working with hand tools.

Chris Schwarz planing a rebate with a shoulder plane

In the picture Chris is planing a rebate with a shoulder plane (a Bridge City Tool Works shoulder plane). It is a simple and effective technique. First you mark the width of the rebate fairly deeply with a marking gauge or a knife. To begin with, you place the corner of the plane in the groove and take a few strokes until you have a clear start. After that you can start tilting the plane down until it is in the right plane and the rebate becomes 90 degrees.

Anarchist square

The second time, the workshop had moved to a monastery in nearby Niederaltaich. They had also changed their name from Dick to Dictum – I wonder why… That time it was two days about saws and sawing. We made the square that Chris uses as his Anarchist symbol. A useful exercise in, among other things, half-lap joints and using a rasp.

Straightedge, winding sticks and wooden square

On the third visit the programme was two one-day courses and a five-day course. I took the two one-day courses. On day one we made a straightedge, winding sticks and a wooden square.

Day two was about planes and how they work. As a group we did an experiment on the effect of setting the chipbreaker as close to the edge as possible. I have previously argued that even though the chipbreaker works to reduce tear-out, it is far too fiddly to get right, and that a small mouth, a sharp iron and, when needed, a plane with a higher angle are enough. But after this exercise I always set the chipbreaker as close to the edge as possible on my smoothing plane.

Planing bubinga without tear-out

In the picture is a piece of jungle wood that the day before had been impossible to plane cleanly but now came out smooth and fine without the slightest tear-out. Here is a better picture of my “bacon shaving”.

I did not take part in the five-day workbench course, but on the first day I joined as Chris's assistant, or slave as he called me, to help everyone get started with their builds.

A recurring highlight is the pleasant dinners with good food, good beer and lots of woodworking talk. They are almost worth the trip in themselves.

Share this content

0.0 0 votes
Please log in to rate this post

These products might interest you