Search on blog

Buy a Gift Card

Cutting Wooden Threads with the Beall Wood Threader

Information
star
star
star
star
star
Be the first to rate

With a Beall wood threader you can cut threads in wood using your router, for example to make wooden screws for clamps, presses and vice screws. Cutting the thread with a router avoids the cross-grain breakage that can happen with a thread box.

Beall wood threader with tap

How it works

The router is clamped directly to the wood and aluminium table and aligned with the supplied aluminium centring sleeve. The dowel is turned through a precision-machined, low-friction threaded insert past the 60° carbide bit, which cuts an accurate external thread without marking the wood.

The internal thread is cut with a matching tap, so screw and nut fit each other.

Step by step

1. Set up
Clamp the router to the table and centre the bit with the sleeve.

2. External thread
Turn the dowel through the insert past the bit.

3. Internal thread
Drill the hole and cut the thread with the tap.

4. To the bottom
Remove the pilot and thread to within 11 mm of the bottom of the hole.

Taps without a bottoming tap

The three-flute combination tap cuts easily and cleanly. It has a removable pilot and can cut a full thread to within 7/16" (11 mm) of the bottom of a hole, so no separate bottoming tap is needed. The larger taps have four flutes so chips clear easily.

The carbide bit never needs sharpening or adjusting and will cut thousands of threads.

Beall wood threader 1 inch

Which size should I choose?

Beall wood threader 1/2 inch

Small screws
1/2" (13 mm).
Beall 1/2"

Beall wood threader 3/4 inch

Clamps
3/4" (19 mm).
Beall 3/4"

Beall wood threader 1 inch

Presses
1" (25 mm).
Beall 1"

Beall wood threader 1 1/4 inch

Vice screws
1 1/4" (32 mm), bit not included.
Beall 1 1/4"

What sizes are available?
Threads are in inches, in six sizes: 1/2", 5/8", 3/4", 1", 1 1/4" and 1 1/2".
Why use a router instead of a thread box?
Routing the thread avoids the cross-grain breakage that can happen with a thread box.
Do I need a bottoming tap?
No, with the pilot removed the tap cuts a full thread to within 11 mm (7/16") of the bottom of the hole.

See the full range: Wood Threader

Share this content

0.0 0 votes
Please log in to rate this post

Discover more