Search on blog

Buy a Gift Card

Tidying Up the Lever Cap

The Plane Doctor
star
star
star
star
star
Be the first to rate
Plane iron and lever cap with damaged front edge

One of the faults I wanted to fix on the plane is the slightly chipped front edge of the lever cap. It is a common kind of damage, since many people simply use it to undo the screw that holds the chip breaker to the iron. That is not such a good idea with brittle cast iron.

New edge line scribed on the lever cap

To start with, I coloured the tip of the cap with a black permanent marker and scribed the new edge line with a height gauge. I then thought it would be a simple matter to file down to the line.

The lever cap clamped in the milling machine

It wasn't that simple, though: over time cast iron gets a hard outer “crust” that the file barely bit into. Out with the heavy artillery. I had to clamp it in the milling machine instead.

A few careful cuts later the damage was gone, and after rounding the edges on a coarse diamond stone it looks perfectly fine.

To be continued… Read part 4: Resoled and Repainted. Previous part: Rust, Rust and Dirt.

Share this content

0.0 0 votes
Please log in to rate this post

Discover more

A New Restoration Candidate
6 May 2013 | The Plane Doctor

A New Restoration Candidate

Rust, Rust and Dirt
11 May 2013 | The Plane Doctor

Rust, Rust and Dirt

Resoled and Repainted
19 May 2013 | The Plane Doctor

Resoled and Repainted

Fully Restored Stanley No. 8
30 June 2014 | The Plane Doctor

Fully Restored Stanley No. 8