Carving tools are described by sweep and width. The sweep gives the shape of the edge and the width is given for each size, so a "No. 5, 13 mm" gouge has a fairly flat curve and is 13 mm wide.

Sweep and size
Sweep 1 is completely straight, sweep 2 is straight but skewed, and higher numbers give an ever deeper curve, where sweep 5 has a slight radius and sweep 11 is almost U-shaped.
Henry Taylor's tools are black on the outside and ground bright on the inside, the blades are 120 mm long and the handles sit well in the hand.
Six blade shapes
Besides the sweep, the tools differ in the shape of the blade along its length. Most come in every sweep, from a very shallow curve to a deep U.

Straight
The most used carving tools, for heavy stock removal and for grooves. Also chisels, skew chisels and V-tools.

Curved
Curved along the length to cut in recesses, inside bowls and curves.

Spoon bent
Like straight gouges, but they reach inside tight curves.

Back bent
Like spoon bent tools, but with the bent end reversed.

Long pod
A slim, parallel shank that widens towards the edge.

Allongée
Tapers all the way back to the bolster. Robust tools for heavy work that let you cut without damaging the foreground.
Hand-forged in Sheffield
The tools are forged by hand. According to Henry Taylor, forging gives a better shape and better metallurgical properties than stamping, and the steel is heat-treated for an edge that gets sharp and lasts. The Acorn tools have been made by Henry Taylor in Sheffield since 1834, with an average hardness of 60–62 HRC, and come sharpened and ready to use.

Which tool should I choose?

Getting started
Five tools for relief carving, with instructions.
Starter set CT5

All-round
Straight gouge, sweep 5, 13 mm.
Sweep 5, 13 mm

Hollows
Curved gouge, sweep 8, 13 mm.
Sweep 8, curved

Deep grooves
Curved gouge, sweep 11, 13 mm.
Sweep 11, curved
What does the sweep number mean?
Do the tools need sharpening before use?
Which tools should a beginner start with?
See the full range: Carving Tools
Share this content