This is the first of what I suspect will be many sporadic posts over a long time. A few years ago, when we were on holiday in the western USA, we passed through Mesa, AZ. I happened to steer the family down a back street to St James Bay Tool Co. After a pleasant chat with the owner I bought a Norris A6 kit. Yes, I thought it was a short while, but my family, sitting outside waiting in 35-degree heat, thought it was an eternity. Can't think what they meant…

Here are the parts of the kit. They are fairly rough. The tails and pins are cut out of the sides and sole, but quite a bit of filing is needed to make them fit together. Behind the mouth there will be a hefty piece of steel. I need to rivet it in place and file it to the right angle.
The right angle, by the way – I have thought about that a lot and settled on 50 degrees being about right. It also fits in among my other smoothing planes. I currently have 45, 47.5, 55 and 58 degrees to choose from.
The kit is fairly basic. A few pieces of steel that appear to be laser-cut, with the basis of the joints in place. The lever cap is cast in brass or bronze – I can't tell which. The iron and chipbreaker are finished. They look really good. The iron is properly sharp and seems to be completely flat on the back. We'll see when it's time for a test cut. Be patient.

The first step was to clean up the inside of the sides and sole, partly to remove some rust and partly to make sure they are even and flat. As usual I used abrasive paper on glass. 80 grit had to do. I may go on to polish the part of the sides that will be visible once the infill is in place.
I have spent quite a long time worrying about how to go about the filing, and of course done a fair amount of research online. So I'll take the opportunity to add some of the best links I have found here:
A forum thread on UK Workshop. It is exactly the kit I have. The difference is that I received neither instructions nor a picture CD.
Peter McBride clearly shows how to file the double dovetail. The penny finally dropped.
An article from ShopNotes with good instructions.
Jim Yehle's page with more useful information
Jerry Schueller's page about his first practice pieces
Gerd Fritsche's blog
A couple of other valuable sources are Jim Kingshott's "Making and Modifying Woodworking Tools" and David Charlesworth's third book.
Continued: The Infill Build Continues – Metalwork.
Share this content