Veritas Marking/Mortise Gauge Heads

Though designed for Veritas wheel marking gauges, these gauge heads are a simple retrofit for any marking gauge with a 5/16" diameter shaft.

Made from carbon steel, the 5/8" diameter wheel cutters will scribe at any point on their circumference and slice rather than tear fibers for clean, accurate cuts. The single-bevel cutters can be used in-line for marking parallel lines, or with bevels facing for sure mortise sizing and chisel registration. Secured with integral set screws, the cutters can be set as close as 3/8" apart. The included shaft collar registers against the gauge fence to keep the shaft parallel to the workpiece, preventing accidental tilting of the cutters; this is especially useful when scribing large offsets from the fence.

Includes:
Two cutters
Shaft collar
Hex key
Instructions