Samson Kamnik Vacuseal Wood, a professional-grade heat-cured resin for stabilising and hardening wood and other porous materials, 1 litre. The resin can be coloured with Koloro P dyes.
Samson Kamnik Vacuseal Wood, a professional-grade heat-cured resin for stabilising and hardening wood and other porous materials, 1 litre. The resin can be coloured with Koloro P dyes.
Equipment:
Vacuseal Wood
Vacuum chamber for wood stabilising
Vacuum pump
Small oven (do not use an oven that will be used for food)
Aluminium foil
Wood at 5% moisture content or less
Safety glasses and protective gloves
Pieces should be dry and clean, ideally at no more than 5% moisture. After drying in the oven, let them cool to room temperature in an airtight container, since dry, hot wood starts absorbing moisture from the air as it cools. Do not stabilise hot pieces, as this causes premature polymerisation.
Stabilisation:
Place the pieces in the vacuum chamber and weigh them down
Add Vacuseal Wood so the pieces are covered by at least 25 mm of resin
Close the intake valve and open the exhaust valve
Run the vacuum pump until there are no or few air bubbles
Release the vacuum and leave the pieces immersed twice as long as they were under vacuum
Remove the pieces, wrap them in aluminium foil and cure at 90 °C for 60-90 minutes depending on size
Remove from the oven, unwrap and let cool at room temperature
Pour unused resin into a separate sealed container and store dark and cool, preferably refrigerated
Wash the chamber with soap and water