Veritas Clamping Kit for Festool MFT/3

This Veritas kit of work-holding accessories lets you harness the full capabilities of Festool's MFT/3 multifunction table. Complete with three hold-downs, two low-profile work stops and eight dogs in two sizes, it lets you position and hold work quickly and securely. All the items have 20 mm diameter posts designed specifically for use with the MFT's 3/4" thick perforated table top.

Don't own an MFT/3? The kit also includes a 20 mm forstner bit so you can create your own workstation using 3/4" material. A through hole in 3/4" thick material is required to secure the toggle clamp plate and the surface dogs with clamping knobs; however, the dogs can also be used without knobs. The surface clamp and low-profile stop can be used in any through hole in material at least 5/8" thick, with no clamping knob required.

The kit comes in a custom black-and-yellow T-Loc Systainer 1 case with a French-fitted liner made of firm closed-cell EVA foam. A contrasting bottom layer lets you see at a glance if anything is missing. Four spots to store Festool accessory clamping knobs are provided; four inexpensive star-shaped knobs are included, but you can just as easily replace them with your own Festool knobs.

The kit includes:
4 small surface dogs
4 large surface dogs
2 low-profile work stops
1 surface clamp
2 Bessey low-profile horizontal auto-adjust toggle clamps (with mounting plates for use in 20 mm dog holes)
4 clamping knobs (for securing the dogs and toggle clamp plates)
1 20 mm forstner bit