- Out-of-Stock
Incra box joint jig for table saws and router tables, with micro-adjustment of joint fit and pin widths of 3–19 mm (1/8"–3/4").
The Incra I-Box is a box joint jig for use on a table saw with a stacked dado or box joint blade set and on a router table with a straight bit. Joint fit is fine-tuned with a dual-pitch lead screw.
The jig runs in a standard miter slot on a GlideLOCK bar and has a built-in miter gauge. It is reversible, so it works on either side of the blade or bit. A wide fence with a reversible MDF sub fence reduces tearout, and front and rear guards cover the blade.
The I-Box also makes decorative centre-keyed and splined box joints and dentil mouldings, and wooden hinges together with the Incra HingeCrafter. Hand screw clamp not included.
Facts:
Pin width 3–19 mm (1/8"–3/4")
Stock thickness 6–22 mm (1/4"–7/8")
Multiple pieces up to 25 mm (1") total thickness
Miter slot 19 × 9.5 mm (3/4" × 3/8"), bar adjustable 18.8–19.4 mm
Made in the USA
You might also like