Incra 90° bend rule, 150 mm, with scales on two surfaces and marking slots every 1 mm wrapping around the edge for marking two faces at once.
Incra Bend Rule, 150 mm. The rule is bent at 90° and has scales on both surfaces, so you can measure and lay out along the edge of a board and mark the top, edge and corner at the same time.
Marking slots every 1 mm wrap around the edge, and a micro-fine hole at every scale line takes a pencil or scribe point. Two vertical end scales make it easy to draw lines parallel to the work edge. The rule is very thin for parallax-free reading, also on flat surfaces.
Also available in 300 mm. Suits the Incra 0.5 mm mechanical marking pencil (sold separately).
Facts:
Length: 150 mm
Scale: metric, on two surfaces plus two end scales
Marking slots: every 1 mm, wrapping around the edge
Marking holes: at every scale line
Data sheet
Specific References
You might also like